3d технологии, моделирование и изготовление.

Если кто пользуется "игрушечным" TinkerCad-ом и еще не справился с проблемой входа, то:
Сделал класс, вход "под учеником" еще работает. Функционал "под учеником" доступен практически весь.
Кому надо - пишите на почту - создам Вас как "ученика" - можно будет заходить и работать без проблем.

Все напечатано. Без ручных операций.

Paul Trainer

This is the first flyable scale model of SpinLaunch's rocket that is launched with a Kinetic Space Launch System (a high speed catapult). The orbital version of this rocket needs to be propelled at Mach 7 through low atmosphere and survive 10,000G (lots of luck!). My scale model is 830mm tall and 81mm in diameter, fully 3D printed in 4 parts, no glue, no paint, no sanding, no drilling. I could have printed it in only 3 parts, but I wanted to have a removeable, single-use nose tip that because of the sharp tip, will break upon landing. It is designed to be replaced after every launch and screws into the payload section of the rocket and costs $0.30 cents. The exploded photo shows the four rocket parts, as well as the screw-in H size reloadable motor and my standard screw-in ebay that is printed in one part using clear resin and contains the electronic altimeter, lipo, igniter, and black powder charge.